Started By
Message

Outboard motor, bad gas? How to fix?

Posted on 6/14/25 at 1:42 pm
Posted by Meauxjeaux
102836 posts including my alters
Member since Jun 2005
45584 posts
Posted on 6/14/25 at 1:42 pm
Picked up a boat from a family member that has a relatively new and nice Yamaha outboard. The gas in it is likely 2-3 years old.

Took it out for test run last week and it cranks up immediately, idles fine and can run up to about 2,500 RPM sounding pretty normal.

But when I try to get on plane, it runs up to 5-6,000 RPM mostly normal, but then starts to sputter and cough and loses power and RPM.

I'm assuming it's the gas.

IF you think so, what's the best thing to do? It's got about a 1/4 tank in it. Should I put some additive "gas revitalizer" kinda stuff and then fill it up with a good non-ethanol gas and just keep running it?

Or drain it and go all fresh?

Or something else?

Thoughts?
Posted by Bigsampson
Fort Worth
Member since Apr 2017
442 posts
Posted on 6/14/25 at 1:50 pm to
Gas lines could be gummed up.
Take off engine and make sure you have free flow.
Put some gas in a clear container.
If it orange. Get rid of it all and flush lines.
Check fuel filters as well. They can hold water and gum up.
When you check the gas, try to get as much as you can from bottom of the tank. Check for water. You would be surprised how much water can get into your gas system over time.
Posted by DownshiftAndFloorIt
Here
Member since Jan 2011
70865 posts
Posted on 6/14/25 at 2:29 pm to
Sounds more like a fuel supply issue to me. If it'll make full power and then starts losing it, its probably a supply issue and not a fuel issue.

Filters, screens, hoses, etc etc
Posted by speckledawg
Somewhere Salty
Member since Nov 2016
4254 posts
Posted on 6/14/25 at 3:13 pm to
Which motor? Had same situation when I bought my boat (Yamaha f115) and thought it was the gas. VERY similar symptoms as you mentioned. Ended up being the injectors. Once I had those cleaned, it ran like a top. Apparently quite common with that motor.

Disconnect the fuel line and run it from a jug of fresh gas. Should answer the fuel question.
This post was edited on 6/14/25 at 3:15 pm
Posted by LEASTBAY
Member since Aug 2007
16232 posts
Posted on 6/14/25 at 3:56 pm to
I would drain and replace fuel lines if possible. Sometimes the inside lining of them delaminate. Better than running crap through the motor.
Posted by mdomingue
Lafayette, LA
Member since Nov 2010
41886 posts
Posted on 6/14/25 at 4:20 pm to
quote:

Sounds more like a fuel supply issue to me. If it'll make full power and then starts losing it, its probably a supply issue and not a fuel issue.

Filters, screens, hoses, etc etc



This is the answer.
Posted by mtcheral
BR
Member since Oct 2008
2077 posts
Posted on 6/14/25 at 5:46 pm to
Sounds like what mine was doing when injectors needed to be cleaned.
Posted by Meauxjeaux
102836 posts including my alters
Member since Jun 2005
45584 posts
Posted on 6/14/25 at 10:29 pm to
quote:

Which motor? Had same situation when I bought my boat (Yamaha f115)


Gonna go see it tomorrow.

Thanks all for the info here!
Posted by Ncook
Member since Feb 2019
721 posts
Posted on 6/15/25 at 8:25 am to
Run ethanol free and Stabil Storage going forward.
Posted by CHEDBALLZ
South Central LA
Member since Dec 2009
23046 posts
Posted on 6/15/25 at 9:32 am to
Go buy a new 2-3 gallon tank with new hose and bulb and go run it. If it runs fine you have a problem with your fuel or fuel lines.

If thats the case.

Drain the tank and refill fresh
Disconnect the gas hose from the motor
Pump the bulb and dump the gas into a container
Replace all fuel lines and bulb
Go run it
This post was edited on 6/15/25 at 9:33 am
Posted by Landmass
Premium Member
Member since Jun 2013
24013 posts
Posted on 6/15/25 at 9:40 am to
If it's an outboard, just hook up another tank of feesh fuel and test.
Posted by Landmass
Premium Member
Member since Jun 2013
24013 posts
Posted on 6/15/25 at 9:42 am to
Run some seafoam through it too.



Posted by Tridentds
Sugar Land
Member since Aug 2011
23304 posts
Posted on 6/15/25 at 10:35 am to
quote:

Gas lines could be gummed up.
Take off engine and make sure you have free flow.
Put some gas in a clear container.
If it orange. Get rid of it all and flush lines.
Check fuel filters as well. They can hold water and gum up.
When you check the gas, try to get as much as you can from bottom of the tank. Check for water. You would be surprised how much water can get into your gas system over time.


^^^
Follow this post exactly. Inexpensive trouble shoot before you get into more complicated and expensive stuff.
Posted by ultralite
Member since Feb 2013
117 posts
Posted on 6/15/25 at 1:08 pm to
Maybe it was just time for me, but I also suspect the freeze this winter did a number on some of my fuel hose ends, especially if coming into a barb at a bend.

When replacing lines and filters/filter o-rings, make sure there’s no air getting sucked in the fuel line.
Posted by Elusiveporpi
Below I-10
Member since Feb 2011
2705 posts
Posted on 6/15/25 at 5:40 pm to
I would put money it’s water in the gas if it’s been sitting. Get a water fuel separator.
Posted by REB BEER
Laffy Yet
Member since Dec 2010
17625 posts
Posted on 6/15/25 at 5:49 pm to
Fresh gas and seafoam.
Posted by KemoSabe65
70605
Member since Mar 2018
6234 posts
Posted on 6/16/25 at 10:21 am to
Drain and fill with fresh gas, Google mercury quicklean cocktail. I believe Techron is the same and cheaper, run multiple tanks through with additive. The more you burn the better off your motor will be.
Posted by ct4lsu
BR
Member since Jan 2008
1204 posts
Posted on 6/16/25 at 10:23 am to
you ran it with gas 2-3 years old?
hopefully you didn't damage the power head
Posted by Stat M Repairman
Member since Jun 2023
863 posts
Posted on 6/16/25 at 4:00 pm to
Have dealt with this issue a lot with boats that have been sitting a long time with ethanol gas.

I'd drain down the tank completely and change the fuel filters.

If the gas has any kind of orange tint to it or a distinctive sweet smell then its for sure bad and you might have a blob of separated ethanol floating around in the tank. Might take off the fuel sender to look down in there.

Separated ethanol can clog the screen on the fuel pickup at the bottom of the tank.

Would also keep in mind that primer bulb has a check valve in it that can also get fricked up. The bulbs themselves are cheap and tend to fail when old.

Also what the poster said above about the inside of the fuel lines deteriorating, have seen that as well.

Change filters and drain down the fuel rail to get clean gas up to the injectors and purge the air out of the fuel rail.

Bad ethanol gas is nasty stuff and causes all kind of expensive problems.
This post was edited on 6/16/25 at 4:01 pm
Posted by redfish99
B.R.
Member since Aug 2007
18634 posts
Posted on 6/16/25 at 5:11 pm to
Shoulda drained that sucker right if the get go regardless of him much was in it. Drain refill treat it with Heet. Then see what u got.
first pageprev pagePage 1 of 2Next pagelast page

Back to top
logoFollow TigerDroppings for LSU Football News
Follow us on X, Facebook and Instagram to get the latest updates on LSU Football and Recruiting.

FacebookXInstagram