Triggerr

New Orleans needs them for the mayor...

Nope, never did...

Same grown men that don’t know how to drive a manuel transmission vehicle of any type. They are what you would call a soy boy...

Maybe start banging her depending on how good of friends you are with the husband. Have a little fun with it ...

Smart move. With covid they aren’t going to put them behind bars...

You in Baton Rouge, I know of one here that did the same. ...

David with Cajun Camo in abbeville. Does a great job, also does camo painting etc...

Submitted April 1, got a number that starts with 330....... and have not heard a thing via email other than the generic email everyone got a couple of weeks back. I called a month ago or so and after talking to someone and being put on hold a number of times I was told it was approved and I should b...

LHSAA is a clown show, not quit as bad as it was when Kenny Henderson was there, but close...

Sorry I am no help here, but I’m curious what someone would use these for. Also doesn’t make more sense to load into 30yd roll offs and sell them to the scrap yard?...

My crews have dewalt, makita, Milwaukee, matebo etc for the most part. Paslode and bostich for nail guns They stay away from rigid, ryobi, porter cable...

Trying to find out what my kids camp out in coastal NC is going to do. Camp seafarer/ camp seagull says they will make the decision around the 15th. I have to fly him up there and I usually spend a day or so plus all camp fees are paid, assuming they will not refund and just ask to keep it until nex...

I always have one on me, from shorts and jeans to $1,500 suite. Never leave home with out it and I’m not a country bumpkin ...

So long story short I think they both had regular gas run in them instead of mix gas by guys that no longer work for us. Now every piece of equipment I own has stickers as to what type of fuel to put in them. These two saws were both less than 6 months old and I think they run $1,200-$1,500/ea. My t...

Looking for an independent guy that works on small 2 cycle engines, maybe even out of a workshop at his house. I have a couple of fairly new Stihl concrete saws that aren’t currently running. I would like to have them broken all the way down and rebuilt. I’m in the BR area, but will travel a little ...

Couldn’t agree more. They aren’t doing anything...

????...

I bet you spend 15 minutes fixing your man bun in the mornings before your boyfriend wakes up ...

So are you looking to build it out of new cypress 6x6, 4x6’s and other sizes. This is very common. My guys cut decorative ends on cypress a lot for brackets, rafter tails etc. Get a design you like, lay it out on the post and cut it. You can use a band saw, sawzall, jigsaw etc. ...

What exactly are you looking for. ...