Page 1
Page 1
Started By
Message

Things to know when getting irrigation system installed

Posted on 5/31/20 at 2:00 pm
Posted by TigerFanatic99
South Bend, Indiana
Member since Jan 2007
27602 posts
Posted on 5/31/20 at 2:00 pm
Crew will be out here tomorrow to start installing an irrigation system. Any tips on what I should be looking out for as they are installing it or things I should make sure I understand before they leave? Will be a Hunter wifi controller and Hunter heads.
Posted by Daponch
Da Nortchore
Member since Mar 2013
996 posts
Posted on 5/31/20 at 7:15 pm to
Take pictures during construction so you know where the main lines are, valves, lateral lines, etc for any repairs in the future
Posted by PlanoPrivateer
Frisco, TX
Member since Jan 2004
2796 posts
Posted on 5/31/20 at 7:55 pm to
I am assuming that you are asking about a residential system. One thing that my wife likes is that ours has 8 stations. Each individual station is dedicated to either the lawn or to the flower beds. If she thinks the flower beds need watering but not the lawn then she can put it on a cycle that only waters the flower beds.
Posted by fightin tigers
Downtown Prairieville
Member since Mar 2008
73681 posts
Posted on 5/31/20 at 7:55 pm to
Yep. Draw it out and try to laminate a copy to keep in the sprinkler box. Your repair guy will thank you later.

Mark where your valves are very well. Boxes grow over.

Prepare for your cable line to be cut if it runs underground.

Prepare for the trenches to settle and need to be filled for the next year.

Get them to show you how to set the sprinkler heads.

Posted by TigerFanatic99
South Bend, Indiana
Member since Jan 2007
27602 posts
Posted on 5/31/20 at 8:40 pm to
quote:

Draw it out and try to laminate a copy to keep in the sprinkler box. Your repair guy will thank you later.


Good note. They did say they will provide both a hard copy and digital copy of a blueprint for the installation after it is complete. I'll make sure they follow through on this.

quote:

Prepare for your cable line to be cut if it runs underground.


Lones were marked clearly just yesterday, including cable. I'll be livid if they cut it.

quote:

Prepare for the trenches to settle and need to be filled for the next year.


I'm top dressing and rolling the entire yard this fall to smooth out a lot of hard bumps in it before overseeding. Maybe I'll go a little over on the trenches expecting it to settle lower under the snowcap this winter.

quote:

Get them to show you how to set the sprinkler heads.


There's 10 visits over 5 years provided as part of the contract specifically for head adjustments as necessary, but this is a good idea, thanks. I've got some large obstacles such as a huge playhouse slide thing from Costco so I expect some work getting dialed in so there are no deadspots.
Posted by TigerFanatic99
South Bend, Indiana
Member since Jan 2007
27602 posts
Posted on 6/5/20 at 8:44 am to
Today is d-day. Six dudes out front absolutely raping and pillaging my yard. I knew they had to dig some holes and run some lines but holy frick it looks like a warzone out there.

I'mma go offer these baws some ice water. Happy worker are workers who care.

How do you say "ice water" in Spanish?
Posted by jimbeam
University of LSU
Member since Oct 2011
75703 posts
Posted on 6/5/20 at 9:03 am to
Ice agua
Posted by Cracker
in a box
Member since Nov 2009
17711 posts
Posted on 6/5/20 at 11:33 am to
I would have drops added to run your water hoses off of the irrigation system.
Posted by RichPoke30
Member since Feb 2009
684 posts
Posted on 6/5/20 at 11:55 am to
agua frio! but honestly they'd all probably rather some bud light at the end of the day.
Posted by Geauxld Finger
Baton Rouge
Member since Jan 2005
31727 posts
Posted on 6/5/20 at 2:24 pm to
1. make sure lwn and turf are on separate zones
2. make sure you know where the lines run (have them give you an as build drawing)
3. make sure you have a master shut off valve
4. make sure you know exactly how to work the controller
5. make sure you know how to shut off the valves manually
6. make sure they install a grounding wire so lighting doesn't strike your controller and fry it
7. make sure your nozzles are adjusted properly and there is minimal overspray
8. make sure they show you how to adjust heads/spray nozzles
Posted by tbrud
Thibodaux
Member since Sep 2004
153 posts
Posted on 6/5/20 at 10:09 pm to
Who are you using? Did you get a good value for amount of work?
Posted by TigerFanatic99
South Bend, Indiana
Member since Jan 2007
27602 posts
Posted on 6/5/20 at 11:24 pm to
quote:

Who are you using? Did you get a good value for amount of work?


It's in South Bend, IN so you probably aren't familiar with them. Company's name is Wessco. I got 4 different quotes and they were the second lowest, and I thought it was a good value.

After seeing the amount of work they did today and what they have left for tomorrow I think it was a great deal. God knows I wasn't going to do that shite. All in I'm out around $4500. It'll be around 6 zones, 30 or so heads, wifi controller. Install looks a bit more complicated than standard because or some obstacles I have. Unfortunately it's not just one or two large clear rectangles.

Posted by xcoach
North LA
Member since Dec 2010
236 posts
Posted on 6/6/20 at 1:01 pm to
Yes, indeed
Posted by slinger1317
Northshore
Member since Sep 2005
5848 posts
Posted on 6/9/20 at 11:01 am to
quote:

Prepare for your cable line to be cut if it runs underground.


I'm having a sprinkler system installed today. LA One Call marked lines last week and again yesterday after the rain.

1 hour in - AT&T Fiber line is history. People are so fricking careless it makes my brain hurt
Posted by ruzil
Baton Rouge
Member since Feb 2012
16915 posts
Posted on 6/9/20 at 9:01 pm to
quote:

AT&T Fiber line is history


That will leave a mark!
first pageprev pagePage 1 of 1Next pagelast page
refresh

Back to top
logoFollow TigerDroppings for LSU Football News
Follow us on Twitter, Facebook and Instagram to get the latest updates on LSU Football and Recruiting.

FacebookTwitterInstagram