Epoxy river table is finally finished

Thank you

When I poured the epoxy I poured it in two layers since it gets hot. The first layer was fine. The second wasn’t measured exactly because the epoxy didn’t harden and was still tacky a week later so I had to remove it and repour. That took forever. Then when sanding the epoxy I noticed imperfection and bubbles that I had to sand the out. That took a while and burned up an orbital sander and had to get another. It’s just labor intensive but can be done.

That looks really good. Very nice work.

Man, that is awesome! What kind of wood is that?

Man that looks awesome. Would love to hear some pointers. I watched this video a few times and my wife and I are going to take on this project. I have never done anything like that and am a little apprehensive. I'm fairly crafty and work with two-part epoxy every day at my job. But it's on a much smaller scale.

For epoxy?

Awesome! That wood would be beautiful on a guitar fretboard

Very impressive