Started By
Message

re: Any HVAC Professionals?

Posted on 5/8/19 at 7:08 am to
Posted by MayhemMike
Austin, TX
Member since Jun 2011
149 posts
Posted on 5/8/19 at 7:08 am to
Thanks for all the responses everyone. Here is some more info.

1580 sqft house
Outside Unit:
M/N 14ACXS030-230A23

Inside Unit
Model #: CX35-48B-6F-2
Posted by notsince98
KC, MO
Member since Oct 2012
18099 posts
Posted on 5/8/19 at 8:10 am to
quote:

Thanks for all the responses everyone. Here is some more info.

1580 sqft house
Outside Unit:
M/N 14ACXS030-230A23

Inside Unit
Model #: CX35-48B-6F-2


OK. This one is a bit complicated. Your builder or HVAC guy may not be too helpful. Depends on how good their customer service is. There are 2 issues that matter in this situation:

1) This is a listed match in the AHRI directory. Here is a link to an AHRI certificate for one like yours. If you know your furnace model #, I can get the exact one for your system: LINK
Since this is a fully matched system, there isn't technically anything wrong with the system that is installed as far as parts go most likely.

2) This system is matched with an oversized indoor coil to squeeze as much SEER out of it as possible. Your AC unit is only 14 SEER but matched with this oversized indoor coil you are getting 16 SEER. This is great as far as energy savings go but it is TERRIBLE as far as comfort goes because it cannot remove humidity at all under marginal loads.

Possible solutions:

1) I'm going to guess the first attempt your HVAC guy will try is reducing the CFM setting. Less warm air across the indoor coil will allow the coil to get colder. The colder the coil gets, the more water condenses on it and the more humidity it will pull from the air. Depending on CFM requirements for proper air distribution throughout your home, this could work or it might end up starving an area of your home with lack of air flow.

2) To get better humidity control might require a different indoor coil. The CX35-30B or CX35-30/36B might be a better option. It should work with your existing furnace. Odds are your installer probably won't want to eat the cost of replacing the coil.

Good luck. I have been in your situation before. I had to force my builder to completely replace my HVAC system because EVERYTHING was sized way too large for my home. Credit to my builder and HVAC guys, though. They did it at no cost. They did not refund me the cost difference for going to a smaller system but at least I have a properly sized and comfortable system now in my new house.
Posted by fishfighter
RIP
Member since Apr 2008
40026 posts
Posted on 7/23/19 at 8:39 am to
quote:

1580 sqft house


Would of went with a 3 ton or bigger unit.
first pageprev pagePage 1 of 1Next pagelast page
refresh

Back to top
logoFollow TigerDroppings for LSU Football News
Follow us on Twitter, Facebook and Instagram to get the latest updates on LSU Football and Recruiting.

FacebookTwitterInstagram