eng08

Very hard wood, I’ve got several pieces to do something similar. The grain is quite twisted so it’s difficult to use power tools without tear out. Here’s a wooden boat builder using it for some key structural prices: [link=(https://www.acorntoarabella.com/)]LINK[/link]...

I bailed and lost my 20%. I bought it solely as a usps play. I find it ridiculous that they chose a company that did t provide what the RFP requested, but wkhs can’t afford the legal fees to fight oshkosh. They should have split the deal....

The panel they tie into will be mostly open and apart to get the transfer switch installed, easiest time to do the upgrade would be then if they tie into old panel....

I take out loans in usdt with the hope it goes off peg ...

Neem or try ground cinnamon...

Mines about 15 years old now, general 25kw. Been running 5 days straight and no issues. I’ll never have another house without one. Recently replaced stator on it for $2k but outside that it’s been an easy $150 yearly Maintenace and a new battery ($90) every 3 years....

What pressure is it under? Maybe some pvc, rubber flex joint pieces and clamps will get you a few days to get the pvc parts, but the store will have pvc too so just do it right first time...

Where’s tigermike? Yolo that shite into something like bnt...

Nola roofing has done well in past, Gunn home improvements did good for the last hurricane ...

Beneficial to be near the substation or main feed lines, cost to tie in can significantly reduce your revenue....

They have some solar operated vent fans you can stick on the sids. Just need to cover or disconnect them in the winter and block off the opening with a piece of foam. You can get fancy and install it on a thermostat to try and regulate temp in the winter as well...

Shoulda done axis’s: $1.5M sale [link=(https://www.coindesk.com/axie-infinity-virtual-land-record-eth-sale)]LINK[/link]...

I’m looking to do that this spring at my camp. Wife required it to be 3 swings wide, so it’s going to get beefy....

Here’s a list of the defi lending abd borrow rates: [link=(https://defirate.com/lend/?exchange_table_type=lend)]LINK - Defi Rate site[/link] If you wanna go full degen you can get higher rates on curve, but they just had an exploit between them and another protocol before they rolled the code out...

I’m in both...

A friend in Northern Europe had his heater go out on his new Tesla - car went forward / back but it was blowing -15 through the vents ...

You in the telegram group? Easier to answer direct messages there...

Got some as a gift, it’s nice...

I got my lamps in the mini greenhouse, it’s handling ~30 plus over outside temp, so all should make it in there. I’ll likely cover all my turnips and beets and lettuce that just sprouted BR is just supposed to be real bad for the one day.....

Desktop metal is the leader in their area...