So the heating element went out on my speed queen commercial dryer. I changed it and the thermal fuse.

This red light is rapidly flashing on the output control board and the green light next to it is slowly flashing.

The heating element is working again.

I don't know if these lights were flashing before I changed the element. Any ideas? I've tried googling but no luck

2 ...

Report Post

Posted by bbvdd

Memphis, TN

Member since Jun 2009

27066 posts

Posted on 6/14/24 at 5:48 pm to LSURoss

Link to codes

Have to go down to dryer and then it’s the second dryer sheet (I think that’s right)

0 ...

Report Post

Posted by Napoleon

Kenna

Member since Dec 2007

70968 posts

Posted on 6/14/24 at 6:35 pm to LSURoss

You need to count the intervals on the flashing light. Not sure of model. The other light if solid is an interval light.
I hate that speed queen is getting away from timers. I recommended them so much because they were still using mechanical timers.

1 ...

Report Post

Posted by LSURoss

Dragon Believer

Member since Dec 2007

16155 posts

Posted on 6/14/24 at 7:05 pm to Napoleon

The pic I snapped just happened to show the red light.

The red light flashes fast and the green light slowly flashes. Maybe once a second.

I just ran a cycle and the dryer is heating. Now that it's cooled down both the red and green light are off.

1 ...

Report Post

Posted by LegendInMyMind

Member since Apr 2019

66786 posts

Posted on 6/14/24 at 7:16 pm to LSURoss

Wonder if it was some sort of test code to make sure it was running right after the parts change?

1 ...

Report Post

Posted by LSURoss

Dragon Believer

Member since Dec 2007

16155 posts

Posted on 6/14/24 at 8:09 pm to LegendInMyMind

Could be. I'm 2 loads through it and everything seems to be working.

I may be over annalizing it, just don't want to burn up another heating element and thermal fuse if there is another underlying problem.

Page 1