- My Forums
- Tiger Rant
- LSU Recruiting
- SEC Rant
- Saints Talk
- Pelicans Talk
- More Sports Board
- Fantasy Sports
- Golf Board
- Soccer Board
- O-T Lounge
- Tech Board
- Home/Garden Board
- Outdoor Board
- Health/Fitness Board
- Movie/TV Board
- Book Board
- Music Board
- Political Talk
- Money Talk
- Fark Board
- Gaming Board
- Travel Board
- Food/Drink Board
- Ticket Exchange
- TD Help Board
Customize My Forums- View All Forums
- Show Left Links
- Topic Sort Options
- Trending Topics
- Recent Topics
- Active Topics
Started By
Message
re: The Official 3D Printing Thread
Posted on 9/28/20 at 9:16 am to DJNOS1978
Posted on 9/28/20 at 9:16 am to DJNOS1978
quote:explain your problem, i can probably tell you the fix. I did every single fix known to mine before i found out what was actually causing the issue. It was mentioned in the comments of a youtube video. no other mention anywhere on the internet.
But I will say lately that I have been having issues with the feeding inside the tube after every print.
1
Posted on 9/28/20 at 12:10 pm to CarRamrod
It starts to back feed at the extruder motor and causes the print to have less material come out.
The issue is the tube feeding into the metal tube. I’m not sure if it is retraction set too high but when I stop the print and pull out the tube you can see the deformed filament at the end of the tube. I’m used to having an extruder heater with a metal tube that has a pfte tube in it that doesn’t move. But this is on a direct drive extruder that doesn’t have the feed tube that goes inside the hot end tube.
I looked at that micro Swiss.
The issue is the tube feeding into the metal tube. I’m not sure if it is retraction set too high but when I stop the print and pull out the tube you can see the deformed filament at the end of the tube. I’m used to having an extruder heater with a metal tube that has a pfte tube in it that doesn’t move. But this is on a direct drive extruder that doesn’t have the feed tube that goes inside the hot end tube.
I looked at that micro Swiss.
Page 1 of 1
Back to top
Follow TigerDroppings for LSU Football News