- My Forums
- Tiger Rant
- LSU Recruiting
- SEC Rant
- Saints Talk
- Pelicans Talk
- More Sports Board
- Fantasy Sports
- Golf Board
- Soccer Board
- O-T Lounge
- Tech Board
- Home/Garden Board
- Outdoor Board
- Health/Fitness Board
- Movie/TV Board
- Book Board
- Music Board
- Political Talk
- Money Talk
- Fark Board
- Gaming Board
- Travel Board
- Food/Drink Board
- Ticket Exchange
- TD Help Board
Customize My Forums- View All Forums
- Show Left Links
- Topic Sort Options
- Trending Topics
- Recent Topics
- Active Topics
Started By
Message
re: what is best way of cutting a trolling motor shaft shorter?
Posted on 3/24/18 at 2:22 am to keakar
Posted on 3/24/18 at 2:22 am to keakar
I am guessing you bought this used otherwise it would be a simple return to the place you purchased it.
Honestly. I wouldn’t even attempt it. I would sell it and get the proper sized trolling motor for the boat. Just my opinion. I could be wrong but I think the process will be a pain in the arse and you are very likely to have future problems with it.
Good luck. Please report back and tell us if you you successfully shorten the shaft and the process you used.
Honestly. I wouldn’t even attempt it. I would sell it and get the proper sized trolling motor for the boat. Just my opinion. I could be wrong but I think the process will be a pain in the arse and you are very likely to have future problems with it.
Good luck. Please report back and tell us if you you successfully shorten the shaft and the process you used.
This post was edited on 3/24/18 at 2:23 am
Posted on 3/24/18 at 3:35 pm to Who Me
quote:
I am guessing you bought this used otherwise it would be a simple return to the place you purchased it.
no its about 10 years old and i had to replace the head 3 times already because it hangs off the side the boat too far. i try to be careful with it but sooner or later stuff happens and its just hanging out side the boat a good foot at least
when i bought it, all i can guess is, the 50" shaft was the short version since i bought it for a flatboat.
whatever the way it happened, im stuck with it now and spending $1,000 to buy another one vs cutting the shaft shorter, im cutting the shaft.
my plan is to slide a smaller pipe inside to protect the wires as i cut, then cut around the outside just enough to get through rather then cutting straight across it. if its hardened steel as i suspect im probably going to end up using around $30 worth of sawzall blades to do it.
just was hoping/fishing for any better ideas
This post was edited on 3/24/18 at 4:18 pm
Popular
Back to top
Follow TigerDroppings for LSU Football News