- My Forums
- Tiger Rant
- LSU Recruiting
- SEC Rant
- Saints Talk
- Pelicans Talk
- More Sports Board
- Fantasy Sports
- Golf Board
- Soccer Board
- O-T Lounge
- Tech Board
- Home/Garden Board
- Outdoor Board
- Health/Fitness Board
- Movie/TV Board
- Book Board
- Music Board
- Political Talk
- Money Talk
- Fark Board
- Gaming Board
- Travel Board
- Food/Drink Board
- Ticket Exchange
- TD Help Board
Customize My Forums- View All Forums
- Show Left Links
- Topic Sort Options
- Trending Topics
- Recent Topics
- Active Topics
Started By
Message
Posted on 8/26/15 at 11:04 pm to Carson123987
My HOR is Shreveport, I'll be in the area visiting early next month. It's good that it's a surface you won't see unless you take it apart. I'm not a fan of the set screws going straight to the receiver though, might take a pin drill and make some divots so the screws have something to go into a little. It's going to scuff up the finish on the receiver anyway. Take time to make lots of test fits, better it fits snug and scuffs the finish than relying on the set screws too much. Looks like something that will have to be checked a few times as the rifle heat cycles too.
ETA: How much clearance do you have between the top of those tabs and the major width of the receiver in that area? Might have to relieve the tabs a bit on top to clear, hard to tell without seeing how much taper there is.
ETA: How much clearance do you have between the top of those tabs and the major width of the receiver in that area? Might have to relieve the tabs a bit on top to clear, hard to tell without seeing how much taper there is.
This post was edited on 8/26/15 at 11:15 pm
Popular
Back to top
Follow TigerDroppings for LSU Football News