Granite supplier on the Northshore

yes, a large piece of granite that I can cut myself.

That would be a slab or a remnant, not a Sheet.

I got YouTube man. People do it all the time. It’s not rocket science. Ty for your help in telling me what the sheets are called.

What do I know. Only the operations manager for a stone fabrication company with 20+ years in kitchen and bath remodeling.

Good luck carrying a (sheet) of granite from your truck to a couple saw horses. And I am sure your neighbors will love the sound of you burning through blades and angle grinders while you “fabricate your project.

And I’m sure your exposed cut edges will look like wet pools of water with perfectly straight lines.

Please post pics of your project.

You're going to be better off finding remnants that are the width you need. Unless you have a forklift you're going to have trouble moving a small slab. Countertop prices are insane, but I get it as the cost to move handle cut fit and finish contribute to that. This thread does have some serious potential though. Good luck and please post some pictures.

quote:

---

You're going to be better off finding remnants that are the width you need

---

I've found some sections(remnants) that are the depth I need. Probably going with quartz since it's already cornered and the edges finished nicely. I'll be butting up a side to a front for the one corner, so the pre-edged quartz will work perfect. I will have to cut three sections of backsplash and finish those enough to stick the cut part to the top. I'll use my current top as a template for the sink. I'm gonna go through $150 in blades and finishing pads. All told I'll be in it for $1,250. When I did my previous house I paid a pro, but that was a little more complicated. Spent $6,000 5 years ago so I figure that's $8,000 now. I think this job would run me $4,500 if I paid someone. My plan for a full slab, if I have to go that route, is getting my saw horses stable on my trailer, and building a working table on top that allows me to have the vendor lay the slab on the sacrificial work surface, already topped with 2*4s elevate the slab for the cuts, and laid out in a way to facilitate those cuts. I can just make all my cuts on the trailer and drive slow(not in the left lane) getting home.

I'm now motivated to do this myself. I'll get pics.

thanks