I think my in-line fuse blew. Will not deploy and the head doesn't light up at all either.

Does anyone know which fuse I need to replace? 30A? 40A? TIA

3 ...

Report Post

Posted by thejudge

Westlake, LA

Member since Sep 2009

15053 posts

Posted on 7/14/24 at 8:37 pm to TigerPimpNationTrank

Search for the manual by brand and check the wiring diagram. Should be listed there.

0 ...

Report Post

Posted by Oescron

Member since Mar 2024

576 posts

Posted on 7/14/24 at 9:08 pm to TigerPimpNationTrank

My power pole sportsman 2 is a 40amp

0 ...

Report Post

Posted by MarshMan

Ponchatoula

Member since May 2015

662 posts

Posted on 7/15/24 at 6:39 am to TigerPimpNationTrank

If it's not lighting up it is most likely the fuse and is usually installed near the power source connection. If the fuse is good then it's the control board. Pull the top cover off the pump, remove the rubber buttons, and pull the control board out. You will see two prongs, the plug that connects the control board to the power source. Sometimes it can get moisture to it and either corrode the connection or fry the control board.

If it is the control board, contact Power Pole Warranty, and they will ship you a new control board and all you have to do is ship the old one back. Their warranty and customer service are top-notch and easy to deal with.

2 ...

Report Post

Posted by Hootie Who

Member since Jun 2020

41 posts

Posted on 7/15/24 at 9:35 am to MarshMan

Might need more info. On the C Monster 1 pumps, the female connection to the main CPU board was an issue also. You can call Power Pole and they can help you with that. Never blew a fuse on mine but it could be that. Different models use different fuses according to the hull truth.

0 ...

Report Post

Posted by TigerPimpNationTrank

NOLA Raised / Northshore Livin'

Member since Nov 2005

3290 posts

Posted on 7/15/24 at 10:28 pm to MarshMan

Thank you very much!!!