re: Official WINK HUB Home Automation thread

I missed the outage.. Was outside filling 27 bags with leaves and using a pole saw to cut some of the trees back leaning dangerously over my screen porch. Then I burned tons of brush and limbs for hours.

Ok tapt:

Do this:

Put wink near tapt.

Go to wink add tapt and stop in green connect now screen.

hold top and bottom buttons down together until they finish being solid, then flashing, then they turn off. THEN count to 15 while still holding then in.

Do the above a second time.

Then hit the green connect now button and watch the wink light.

Mine went for a long time flashing then turned RED... Then 2-5 seconds later blinked green twice.. Very briefly.

Hit cancel

Went to lights.. Nothing there, the offline light controlled by tapt had disappeared.

Went to switches and it was back online. Under tapt settings it said nothing connected so I changed it to basic light.

Went to lights and my porch lights were back, did not have to rename it or anything.

I'm good to go now.