Need help wiring garage door sensors....

This. Sensor wires go into those inputs. Dunno what the colors are so better look it up

[quote]
Quick connect plug-in terminals

Each sensor has two wires, solid white and white with a black stripe. Strip a 7/16 inch of insulation from each wire for both sensors.
2. Twist the two white w/black stripe wires from both sensors together.

3. Twist the two white solid wires from both sensors together.

4. Connect the two white w/black stripe wires in the gray terminal on the motor unit.

5. Connect the two white solid wires in the white terminal that is next to the gray on the motor unit.

Quick connect plug-in terminals using pre-existing wires

1. Strip a 7/16 inch of insulation from each wire white solid and white w/black stripe on both sensors.

2. Whatever color wire you are splicing to the white w/black stripe wire, connects to the gray terminal on the motor unit.

3. Whatever color wire you are splicing to the solid white wire, connects to the white terminal that is adjacent to the gray terminal on the motor unit.


Note: To release or insert wires into the quick connect terminals, push in the tab below the terminal with the tip of a screwdriver.









ETA sorry first image isn't yours.

On your model red and the one next to it are for the inside button or a wall plate. The grey and the one next to it are for the sensors.


If you have red and black instead of white and a strip then red=white and black = stripe.

I knew Napolean would handle this one