re: Homebrewing: All Grain Mash Tun

quote:

---

anybody have any plans/materials list for one?

---

- Rubbermaid 10 gallon round beverage cooler
- all stainless steel ¼” hose clamps x 2
- brass square head plug (Watts A-737)
- ½” x 12” (or larger) braided stainless steel supply hose
- 3/8” female barb adapter (Watts A-298)
- 5/8” stainless steel fender washer (sometimes hard to find, but try Fastenal or read this thread if you are stuck)
- 3/8” MIP x 1-1/2” brass nipple (Watts A-786)
- seal from plastic spigot of cooler (shown below)
- Teflon tape (note: everything to the left of the tape in the picture above goes inside the cooler, and everything to the right goes outside)
- 5/8” O-ring (preferably heat resistant, if you can find one)
- 3 x 5/8” fender washers
- 3/8” threaded ball valve
- 3/8” male barb adapter (Watts A-294)

Link to HBT thread on it.