Started By
Message

re: New Construction HVAC question

Posted on 11/2/18 at 9:25 am to
Posted by baldona
Florida
Member since Feb 2016
20585 posts
Posted on 11/2/18 at 9:25 am to
quote:

I am a contractor and have seen major issues with people oversizing their HVAC tonnage.

Poor insulation or improper HVAC is a major problem that can damage your home and make you sick.

You want the AC to run for a while to remove the moisture in the house.


Wow. First off, you don't run your AC primarily to remove moisture and humidity. You would be better off running ceiling fans and a dehumidifier financially. Hell of a lot cheaper.

If someone is having issues with circulation that's a whole different issue. Could be poor ducting for one. There's a multitude of reasons outside of simply too big of AC. I've seen mold issues from poor circulation in houses with too small of an AC too.

Again, 2550 is by no means too small for a 6 ton system. 400-500 sq ft is the recommended sq footage per ton. OP is very much on the border of needing a 6 ton. 5 ton will be fine, but its a new build so why would you not spend a little more on a slightly larger unit to give you some room for error?

ETA: Yeah there are programs that determine your need, in a perfect condition. You have a wife and kids at home going in and out through the doors all day? Imperfect. You install a doggy door that seeps warm air from the outside and you don't know it? Imperfect.

Outside of car salesman, HVAC industry is about as slimy as it gets. They will quote you and sell you on all kinds of BS you don't need or want just because it makes them money.
This post was edited on 11/2/18 at 9:33 am
Posted by td1
Baton Rouge
Member since Oct 2015
2844 posts
Posted on 11/2/18 at 10:04 am to
Replaced 1 2 Stage Lennox 4 ton, 1 2 Stage Lennox 2 ton, 1 2 Stage Lennox 3 ton three years ago all at the same time. The original units were 30 years old, narry an issue for all 30 years besides one cap.

Since the replacement, metering valve on the 4 ton coils had to be replaced, then the compressor bit the dust, and most recently the coils sprang a leak and were replaced. All under warranty, but didn't include labor and Freon. The 2 ton has a leak in the coils and will be worked on next. The 3 ton is upstairs and doesn't get used that often so it may or may not have an issue.

The remaining "old" unit is a RUUD 3 ton single state we replaced in 2003. Not a single issue from it from day one.

The only advice I have is brand. Lennox is not what is used to be!
Posted by tes fou
Member since Feb 2014
838 posts
Posted on 11/2/18 at 8:53 pm to
quote:

400-500 sq ft is the recommended sq footage per ton.


This is true when talking about replacements, but a modern home with quality insulation, radiant barrier, high quality windows and good weather sealing should not be anywhere near 400 sq ft per ton.

first pageprev pagePage 1 of 1Next pagelast page
refresh

Back to top
logoFollow TigerDroppings for LSU Football News
Follow us on Twitter, Facebook and Instagram to get the latest updates on LSU Football and Recruiting.

FacebookTwitterInstagram