- My Forums
- Tiger Rant
- LSU Recruiting
- SEC Rant
- Saints Talk
- Pelicans Talk
- More Sports Board
- Fantasy Sports
- Golf Board
- Soccer Board
- O-T Lounge
- Tech Board
- Home/Garden Board
- Outdoor Board
- Health/Fitness Board
- Movie/TV Board
- Book Board
- Music Board
- Political Talk
- Money Talk
- Fark Board
- Gaming Board
- Travel Board
- Food/Drink Board
- Ticket Exchange
- TD Help Board
Customize My Forums- View All Forums
- Show Left Links
- Topic Sort Options
- Trending Topics
- Recent Topics
- Active Topics
Started By
Message
re: Has anyone attempted to make a homemade Buck Boiler?
Posted on 12/2/15 at 9:22 am to lsumeyers
Posted on 12/2/15 at 9:22 am to lsumeyers
I do ~20 skulls a year with the one I built. Used a horse feed bucket from Tractor Supply (due to it having the flat back), used appropriate sized hole saw to drill the hole in that flat side, insert 1500W element with the rubber washer into bucket (washer being on the outside) and used a 1" conduit nut on the inside. when you tighten the nut on the inside, it squeezes the washer on the outside, eliminating the need for the conduit hub. Will try to post pics later.
ETA: I like it wayyyy better than propane and pot because: no open flame, no need to worry about running out of propane, and consistent temperature. the 1500W keeps a good simmer, because if you boil the skull that is when the cartilage breaks down and your nasal bones and teeth fall off.
ETA: I like it wayyyy better than propane and pot because: no open flame, no need to worry about running out of propane, and consistent temperature. the 1500W keeps a good simmer, because if you boil the skull that is when the cartilage breaks down and your nasal bones and teeth fall off.
This post was edited on 12/2/15 at 9:25 am
Posted on 12/2/15 at 10:04 am to bootlegger
Bought a 20qt flat back feed bucket, a 1500w 120v heating element, and a 1" conduit port. I drilled a hole about an inch up from the bottom on the back, fed the element through the hole, and connected the port from the inside. This set up worked better than the Buck Boiler, but there were a few design flaws that can be overcome. It leaked sometimes around the seal so I am going to put Gorilla glue in the port and around the seal. For twenty bucks total it was well worth it. The head came out clean.
This post was edited on 12/7/15 at 8:42 am
Popular
Back to top
Follow TigerDroppings for LSU Football News