re: :Clames: :Propagandalf: AR help

quote:

---

My HOR is Shreveport, I'll be in the area visiting early next month. It's good that it's a surface you won't see unless you take it apart. I'm not a fan of the set screws going straight to the receiver though, might take a pin drill and make some divots so the screws have something to go into a little. It's going to scuff up the finish on the receiver anyway. Take time to make lots of test fits, better it fits snug and scuffs the finish than relying on the set screws too much. Looks like something that will have to be checked a few times as the rifle heat cycles too.

---

Didn't know you were military. Always thought you were some type of engineer. I was planning on dimpling the receiver with a pin drill, similar to dimpling a barrel for gas block set screws.

I'll definitely have to run some tests. I'll keep yall posted

If you're ever in BR, be sure to stop at Bowie Outfitters and I'll show you the works