Started By
Message

re: questions on smoking 8 butts in WSM

Posted on 3/24/14 at 9:58 am to
Posted by HungryTiger
New Orleans
Member since Jan 2006
724 posts
Posted on 3/24/14 at 9:58 am to
I have the same size WSM and the most I have done was a full shoulder, with the pic nic and butt separated. If memory serves, it was around 20 lbs. I don't think I could have done more than double that, because the top rack was just big enough. Considering that the middle rack is typically at a bit lower of a temp than the top (with heat rising), I wouldn't push the volume you try to cook on the bottom.

As far as time and temp, with pork shoulder being pretty forgving, I would try to hold steady around 300. Go with the minion, but for any long cook (like brisket) I usually have to light a fresh batch of coals in a chimney starter to keep it going. So get one of those if you don't have one already.

Honestly, with that amount, I would justgive the meat about 6-8 hours of smoke, then finish them covered in an oven. It will much easier for you to get the internal temp to the point that you can pull. You can still get a great result, and you won't risk the food not being ready when you need it. I've done shoulders well ahead of when I needed them, and just held them warm in a an ice chest wrapped in foil once they were done. When you're ready, the meat will still be piping and perfect for pulling.

ETA: This may go without saying, but insert you probe thermometer into the center of the largest cut you have. I would pull them all once that hits 190 since the smaller cuts should be higher and the carry over should easily take them to 200ish even if you rest them and serve immediately instead of wrapping and holding warm for later.
This post was edited on 3/24/14 at 10:09 am
Posted by Midget Death Squad
Meme Magic
Member since Oct 2008
24756 posts
Posted on 3/24/14 at 10:20 am to
quote:

give the meat about 6-8 hours of smoke, then finish them covered in an oven



I may do this, that way I can work in batches. I was a bit concerned with doing both racks, but I figured I would be able to pull it off. Your suggestion may ultimately be the better option.

quote:

just held them warm in a an ice chest wrapped in foil once they were done


In the past I have wrapped and put in oven set at 160. This has worked; however, the bark gets soft. My guess is in the ice chest it will too, but by some chance does it not?


ETA: Another thought I just had... what if I rotate the racks mid cook? I'm thinking this would allow all meat to get equal temp time. If i put my probe on mid rack and maintain that at 260, then top rack should be around 280 or so, right?
This post was edited on 3/24/14 at 10:22 am
first pageprev pagePage 1 of 1Next pagelast page
refresh

Back to top
logoFollow TigerDroppings for LSU Football News
Follow us on Twitter, Facebook and Instagram to get the latest updates on LSU Football and Recruiting.

FacebookTwitterInstagram