Shower door bumping in top corner. How to level?

I adjust mine all the time. That heavy glass slides in the rubber gasket.

Make sure to support the door (I recommend an air bag pump shim thing like I’ll link below). Have it a little open or closed so when it’s loosened it doesn’t lean on the fixed panel.

Loosen the top screws on one side of the hinge just enough so the door becomes movable.

Pump shim up until door has an equal gap top to bottom

Tighten screws as reasonably tight as you can without stripping them

Release air from shim and remove.

With a 9’ door I would have someone standing there just holding the handle of the door to not let it move. If it was a shorter door you could have one hand on the handle and use the other to do the screw work but you’ll have to be on a ladder for 9’.

https://www.homedepot.com/p/Calculated-Industries-Contractor-Grade-AirShim-Inflatable-Pry-Bar-and-Leveling-Tool-that-Holds-Up-To-300-lbs-1190/206697086?source=shoppingads&locale=en-US&pla&mtc=SHOPPING-BF-CDP-GGL-D25H-025_001_HAND_TOOLS-NA-Multi-NA-PMAX-NA-NA-NA-NA-NBR-NA-NA-NA-Hand_ToolsPMAX&cm_mmc=SHOPPING-BF-CDP-GGL-D25H-025_001_HAND_TOOLS-NA-Multi-NA-PMAX-NA-NA-NA-NA-NBR-NA-NA-NA-Hand_ToolsPMAX-71700000117978840--&gad_source=1&gbraid=0AAAAADq61Ufg06TPWeu39YxesT7NHbFPa&gclid=Cj0KCQjw_-GxBhC1ARIsADGgDjvo9_cpjUmCQDf4y6OsQGVEV8rG1E5DqOpZZG4rhFaune5oE71oqyUaAuNYEALw_wcB&gclsrc=aw.ds

I'll tell you if you or your wife take a pic with your tits pressed against it for us.

Will be funny one way and obviously appealing the other. I'll let you decide which.

Honestly though, nice shower. Was that a tub to shower conversion?

You can adjust those hinges OP. The above with the air shim is a great post. Here’s the issue though, if it’s only been a year they may have made that gap between the glass panels too small. I had this issue in a previous home, they only fabricated the gap to be under 1/4. As said those panels are very heavy, depending on the movement they aren’t hard to adjust just heavy and if your gap is very small you are only talking a really small adjustment. It may take a glass professional to do it is what I mean. It’s much better to have a slightly larger gap and have a plastic strip that seals the gap. That way you have more room for adjustment.

Tempered glass can’t be modified.

OP - You make me feel good about the amount of shite my wife has in the shower. Thanks.

While your at it
Add a 3rd hinge...... by a professional

Will take some load off the other 2